Solex 44PA1
What Can I Do About a Leaking Accelerator Pump Cover.

This can be caused from years of over tightening of the accelerator pump cover resulting in a warped cover. Whenever we rebuild one of these carburetors we resurface both the bowl and the accelerator pump cover. We have a nice flat grinder that does a good job, but you could also use a good flat file. Make sure you keep the flat file flat on the surface and file from all angles. The high spots will be at the screw holes. You could also use a little Permatex Anerobic gasket maker, but use very little and only around the outside edge. You don't want any mixing with the fuel.

 

 

Protect your carburetor from ethanol damage with our enzyme additive.

Solex 44PA1 Rebuild Instructions
Watch a video about this carburetor.
ENGINEMAIN JETFUEL PUMP PRESSURE
AQ120B, AQ125A1552-4 PSI
AQ145A1452-4 PSI
Can't find what you need? Contact Us
TOP