1. Home
  2. Technical
  3. HOLLEY Carburetor Technical
  4. Holley 2210, 2211, 2245 Technical
  5. Holley 2245 Power Circuit
How the power circuit works

As the engine gets up to higher speeds, more fuel is needed, which is provided by the power jet.

At idle the vacuum is at it's highest which pulls the power piston up allowing the power jet, or power valve stem to move up, cutting off fuel through the power jet. As rpm increases and vacuum to the power piston drops, the stem drops down and pushes the power jet stem down, opening up the flow of fuel. This allows extra fuel to flow into the main jet circuit giving that extra kick of fuel.

This particular carburetor does not use a gasket on the bottom of the power valve.

Holley 2245 Power Jet

Holley 2245 Power Piston

Watch a video about the 2245 power circuit

Lack of power at high speeds
  • Power piston binding - it should move up and down freely. Remove the piston by flicking the stem up and down to break the staking. Use something like silicon spray lubricant to clean out the piston well.
  • Power piston spring missing, or bad - replace the piston spring.
  • Power piston stem bent - the stem needs to be straight, or it will miss the power valve stem.
  • Power valve (jet) is dirty - use carburetor cleaner to clean until the stem moves up and down freely. Blow through all of the holes. The power valve is all brass and there is no rubber to replace.
  • Fuel pump pressure is low, or the float adjustment isn't correct.
  • Blow through the bottom of the power jet while moving the stem in and out. All the way out should cut off the flow of air.


Can't find what you need? Contact Us
TOP