4 Jet Governor

Disassembly of the 4G Governor

Don't forget to take plenty of photos.

1. Throttle Lever and Bearing Assembly

   • Remove the throttle lever and bearing assembly by taking out the (4) attaching screws and lockwashers.

   • Pull outward on the lever assembly and remove the gasket.

2. Governor Housing Side Plate

   • Break the wire seal (if used) and remove the (4) attaching screws holding the governor housing side plate.

   • Carefully remove the side plate.

3. Governor Diaphragm

   • Remove the (10) diaphragm cover attaching screws.

   • Take off the diaphragm cover to expose the diaphragm.

4. Diaphragm Plunger Rod

   • Disconnect the diaphragm plunger rod from the governor lever by removing the clip at the rod’s end.

   • Pull the governor diaphragm out of the housing.

5. Governor Spring

   • Remove the governor spring by sliding it off both the stationary pin and the pin on the governor lever.

6. Throttle Shaft Levers

   • Take off the (2) 11/32" nuts and lockwashers on the ends of the primary and secondary throttle shafts.

   • Remove the secondary throttle lever and closing spring (note their orientation for reassembly).

7. Governor Lever and Link Assembly

   • Remove the governor lever, link, and secondary valve actuating lever as a complete assembly .

Notes

• Keep track of spring orientation, lever positions, and link assembly arrangement, as these will be critical during reassembly.

• The manual emphasizes cleaning thoroughly after disassembly but avoiding harsh solvents on rubber, leather, or diaphragm components.