Stromberg WW, 2 barrel carburetor rebuild kit. New, currently being produced. Designed for today's gasoline.
Meets or exceeds manufactures specifications
Leather accelerator pump (ethanol ready)
Viton tip needle & seat
Flange (mounting) gasket
Idle mixture screws w/springs
Throttle body gasket
Float bowl gasket
Main discharge gasket
Carburetor kits will often contain more parts than you will need for your carburetor.
|1961 Le Sabre||7-114, 7-114A|
|1953-54 D-44, D-48, D-50, D-53||3-105, 3-105A, 3-106, 3-108, 3-108A, 3-109, 3-109A|
|1972-73 305", 351", 379"||23-244, 23-248, 23-257|
|1963-64 Challenger, Cruiser, Commander, Hawk, Lark||6-130, 6-132|
|1963-64 8E7, 8E9, 8E12, 8E13, 8E28, 8E40||6-130, 6-131, 6-132, 6-133|
There are several WW kits and they depend on the carburetor number.
Clean (using any parts store dip). Follow directions on can.
Wash with hot water
Blow out all passages
Run thin wire through all passages. Cleaners will not remove ethanol residue.
Blow out again
Polish the accelerator pump well so that the cup glides smoothly.
Apply a few drops of oil to the leather cup before installing.
Rebuild kit, made in the USA from high quality ethanol ready parts. Everything shown in the photo is included in the kit, additional parts may be purchased by choosing your carburetor type in our main catalog. For additional help including rebuild videos, free manuals, and troubleshooting, please see our technical section.
For additional information see related tabs above.
To confirm this kit matches your carburetor number refer to the application/carb tab. To make sure you get the correct carburetor kit, please match your carburetor number with the list provided. This kit is good for the carburetor numbers listed only. No return on opened kits.