1. Home
  2. Technical
  3. How a Carburetor Works
How a Carburetor Works

Basic Carburetor

Fuel enters the carburetor through a fuel inlet. The float regulates how much fuel to let in. When the float bowl has enough fuel the float moves up and shuts off the fuel via the needle valve. As the fuel level drops, the float drops down and allows the needle valve to open.



Fuel enters the carburetor throat through a main discharge passage. Fuel is drawn by the vacuum created in the carburetor bore. The fuel is then mixed with air that is drawn in from the top of the carburetor bore, facilitated by the venturi. When the engine is cold the choke valve is partially closed restricting the air flow. This richens up the air/fuel mixture allowing the engine to start & idle cold.

The throttle valve is used to restrict the air/fuel flow. It starts at a closed position and as it is opened by the throttle linkage the air/fuel mixture is allowed into the intake manifold.

Idle Circuit
Idle Circuit

The idle circuit is built into carburetors so that your engine can idle without dying. When the throttle valve is closed when at a stop there is little to no air going into the intake manifold. If it wasn't for the idle circuit, the engine would die.

As you can see in the illustration fuel is fed through the low speed jet and down to the idle screw port using the strong vacuum being created below the throttle valve. Air is introduced and mixed with the idle fuel using some sort of air bleed.

Note that once the throttle valve opens, the idle circuit is bypassed, so be sure you are doing your idle mixture adjustment at idle speed.



When the throttle valve is opened a bit, but the RPM is still low, most carburetors will allow a bit more fuel into the intake via auxiliary holes.
Can't find what you need? Contact Us
TOP