Electric Choke Conversion Kit - CU1274

Works great, I just couldn't use the bracket that came with it. It was about 1/2 an inch off so it wouldn't line up with the holes, but other than that my choke opens up within minutes. Oh, and the instructions make things really easy

Customer service with Crystal was great and my order was received promptly. I took a shot in ordering this part not knowing if it would fit my application....and it didn't. I was impressed with the quality of the part and the directions for its installation. I will continue to use Mikes for any future needed parts

This unit was purchased to replace an old divorced choke unit that was inconsistent in its operation. This electric choke has transformed the starting procedure of my old Chrysler from major grief to just a flick of the ignition key. Well worth the investment, saving me the cost of a new Holley carb as this was going to be last resort to cure the Chrysler's starting issue. One small criticism would be that the mounting bracket needs to be a little beefier as the choke unit does move slightly as the current bracket flex's. However, this 'flex' does not seem to affect the operation of the choke unit itself.

PRODUCT FIT EDELBROCK DECENT HAD TO MAKE A GASKET TO SEAL HOLE OFF ON INTAKE MORE FRO APERRANCE BUT CHOKE CONVERSION DID WORK

I got a 68 Dodge 318 in my Polara with a heat riser valve clock spring broken, and a blocked exhaust passage in the intake manifold, so basically the mechanical choke will not work properly, this electric choke is working very good and very easy to install also adjust, it just kinda expensive than a new spring or junkyard heat riser assembly, and cheaper than a nos heat riser. Beside fixing the mechanical choke I will have to spend time to remove passenger side header to remove n install new spring/heat riser assembly, also remove intake manifold and clean the exhaust passage, and to remove intake manifold, coolant in the car have to drain down because it pass intake manifold. Install a bolt on electric choke save a whole afternoon of my weekend also it’s a small upgrade for the engine. It’s a 2 hours work vs. 30 min wrenching n wiring. I will highly recommend this product to everyone who have a 318 in their car and suffering by choke problem. Of cause someday I still will take that intake out and clean the passage, but heat riser I just weld it open all the time.

Bolt-on fit for a '66 273 stromberg and doing its job well.

I really appreciated the packaging. I took a chance that your item would work on a 1976 Dodge 318 Carter 2 barrel. I had to modify the mounting holes incorporating slots since the linkage was not vertical and choke body was blocking the vacuum tube on the side of the carb. All worked out well. Furthermore, the construction is of excellent quality. Thank You, Dana